Many new dimmers no longer have terminal wires and use screw terminals that might be similar to the ones on the switch you removed instead. If the wires are flattened, nicked, or damaged, clip off this portion of the wire and strip a 3/4-inch fresh section. Are common at the ends of hallways or staircases and in rooms that have two points of entry. TREATLIFE Smart Ceiling Fan Control and Dimmer Light Switch, Neutral Wire Needed, 2. shellydimmer2-35AF58) that you connect to using a mobile device. Restore power to the circuit and then the Shelly will boot up in access point mode and broadcast a Wi-Fi network (e.g. The basic steps for configuring all the versions of Shelly relays are the same. Next, using a pair of needle-nose pliers, wrap the bare ground wire around the green screw at the bottom of the new standard switch. Configuring the Shelly Dimmer 2 Step one: set up Wi-Fi. Loosen the screw that holds the grounding wire to the switch and remove the dimmer switch from the switch box.

Straighten out any loops in the copper wires, using needle-nose pliers. Disconnect the traveler and/or common wires from the dimmer switch. The new dimmer switch will be connected to the circuit wires using wire nuts or another form of wire connector, so the circuit wires may need to be straightened. If your switch is attached via push-in fittings on the back, you can remove them by pushing a small nail into the release slot next to each push-in screw terminal, or simply clip them off with your wire cutters and re-strip them to the proper length. If that's the case, simply unscrew them and untwist the wires. Alternatively, your old switch might be connected with wire nuts. This could be two separate switches in two different rooms, for example. If a ground wire is also attached, disconnect it from the green ground screw. A 2-way dimmer switch allows you to control one light from two locations. The Spruce Home Improvement Review Boardĭetach the circuit wires by loosening the screw terminals on the side of the switch and pulling the wires free.

2 wire dimmer switch